Computer Accessories User Manual

286 Appendix C MX5X CE .NET 4.2
MX5X Reference Guide E-EQ-MX5CERG-F-ARC
Symbol Client (CE .NET 4.2 only)
Note: When making changes to profile parameters, the mobile device should be warmbooted
afterwards unless noted otherwise.
Prerequisites
• Windows CE .NET 4.2 operating system
• Network SSID or ESSID number of the Access Point
• WEP or LEAP Authentication Protocol Keys
Access: Tap the Network Connected Icon in the Status Bar
IP Information Tab
After the IP Address has been assigned to the mobile device, tap the Renew button to renew the IP
address if necessary. Tap the Details button to view the Network Connection details.
IPv6 Information Tab
This is the TCP/IPv6 information screen. The contents cannot be edited by the user.
Configuring IPv6
By default, IPv6 is enabled and an IPv6 broadcast message is sent on power up. To disable IPv6,
run \Windows\ipv6Disable.reg and perform a warmboot. To enable IPv6, run
\Windows\ipv6Enable.reg and perform a warmboot. Contact your LXE representative for
ipv6Disable.reg and ipv6Enable.reg availability.
Note: These utilities affect the behavior of the IPv6 on warmboot. After a coldboot, IPv6 is
enabled.
Wireless Information Tab
Factory Default Settings
Wireless Information tab
Notify when new networks available Enabled
Advanced Button
Use Windows to configure wireless settings Enabled
Automatically connect to non-preferred networks Disabled
Networks to access (Only Apps, Only comp-to-comp) All available
Encryption (WEP, TKIP) WEP
Authentication (WPA, Open, Shared, WPA-PSK) WPA
Ad hoc network Disabled
Key provided automatically Enabled
Enable 802.1X authentication Enabled
EAP Type (MDF-Challenge, PEAP, TLS) TLS