Computer Accessories User Manual

302 AppLock Error Messages
MX5X Reference Guide E-EQ-MX5CERG-F-ARC
Message Explanation and/or corrective action Level
Reset system work area failure The system work area is adjusted when in user mode to
cover the taskbar area. The system work area has to be
adjusted to exclude the taskbar area in administration
mode. AppLock was unable to adjust this area.
LOG_ERROR
Shift pressed The Shift key has been pressed and trapped by the
HotKey processing.
LOG_EX
Shift Processing the hotkey and backdoor entry LOG_EX
Show taskbar The taskbar is now being made visible and enabled. LOG_PROCESSING
Switching to admin-backdoor The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of the backdoor key presses were entered by the
administrator.
LOG_PROCESSING
Switching to admin-hotkey press The system is currently in user mode and is now
switching to admin mode. The switch occurred because
of a hotkey press by the administrator.
LOG_PROCESSING
Switching to admin-kbdhook.dll not
found
The keyboard hook load failed, so AppLock switches to
admin mode. If a password is specified, the password
prompt is displayed and remains until a valid password
is entered.
LOG_PROCESSING
Switching to admin-keyboard hook
initialization failure
If the keyboard hook initialization fails, AppLock
switches to admin mode. . If a password is specified,
the password prompt is displayed and remains until a
valid password is entered.
LOG_PROCESSING
Switching to admin-registry read
failure
See the explanation of the “Registry read failure” above.
AppLock is switching into Admin mode. If a password
has been configured, the prompt will be displayed and
will not be dismissed until a valid password is entered.
LOG_PROCESSING
Switching to TaskbarScreenMode In administration mode, the taskbar is visible and
enabled.
LOG_EX
Switching to user mode The registry was successfully read and AppLock is
starting the process to switch to user mode.
LOG_PROCESSING
Switching to user-hotkey press The system is currently in admin mode and is now
switching to user mode. The switch occurred because of
a hotkey press by the administrator.
LOG_PROCESSING
Taskbar hook failure AppLock is unable to control the taskbar to prevent the
locked application from re-enabling it.
LOG_ERROR
Taskbar hook OK AppLock successfully installed control of the taskbar. LOG_EX
Timeout looking for app window After the application is launched, AppLock must wait
until the application has initialized itself before
proceeding. The application did not start successfully
and AppLock has timed out.
LOG_ERROR
ToUser after admin, not at boot The user mode switch is attempted when the device
boots and after the administrator presses the hotkey.
The mode switch is being attempted after a hotkey press.
LOG_EX
ToUser after admin-app still open The switch to user mode is being made via a hotkey
press and the administrator has left the application open
and has not made any changes in the configuration.
LOG_EX
ToUser after admin-no app or cmd
line change
If user mode is being entered via a hotkey press, the
administrator may have left the configured application
open. If so, AppLock does not launch the application
again unless a new application or command line has
been specified; otherwise, it just locks it.
LOG_EX
Unable to move desktop The desktop is moved when switching into user mode.
This prevents them from being visible if the application
is exited and restarted by the timer. This error does not
affect the screen mode switch; processing continues.
LOG_ERROR
Unable to move taskbar The taskbar is moved when switching into user mode.
This prevents them from being visible if the application
is exited and restarted by the timer. This error does not
affect the screen mode switch; processing continues.
LOG_ERROR