Dear Customer, H you follow the recommendations contained In this Instruction Manual, our appliance will give you constant high performance and will remain efficient for many years to cons. CONTENTS RECOMMENDATIONS AND SUGGESTIONS CHARACTERISTICS INSTALLATION & USE MAINTENANCE RECOMMENDATIONS AND SUGGESTIONS I — INSTALLATION * The manufacturer will not be held liable for any damages resulting from incorrect or Improper Installation.
* Disconnect the electrical plug prior to any maintenance. * Children don't recognize the risks of electrical appliances. Therefore use or keep the appliance only under supervision of adults and out of the reach from children. * Don't use this product outdoor.
CHARACTERISTICS DIMENSIONS INSTALLATION & USE LL USE ONLY WITH RANGE HOOD CORD CONNECTION KITS THAT HAVE BEEN INVESTIGATED AND FOUND ACCEPTABLE FOR USE WITH THIS MODEL RANGE HOOD. Note 1: On stainless steal hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and chimney prior to final installation. Note 2: At least two people will be required to mount the hood. INSTALLATION DRILLING AND LINING ‘1.
DUCT FIXING Caution: To reduce the risk of fire, use metal duct work only. (Metal duct should be sourced by locally.) 1. Attach an adequate length of < 6° round duct on the top the outlet adapter. 2. Secure the duct using fastener. Make sure the duct is fixed well on. TELESCOPIC CHIMNEY ASSEMBLY Chimney Bottom 1. Carefully slide the chimney bottom down outside the chimney top partly, then carefully place the chimney bottom into the recessed area of the hood body top. Chimney Tep 1.
The hood is operated by using F11 soft touch control (remote control is included) SOFT TOUCH CONTROL SWITCH The hoods may be operated using the soft touch control on the front panel. The lights switch turns the lamps on and off. The blower switch tums the blower on to three speed settings: 1-Lamp 2-PLUS £ + Ree oy MINUS ON/OFF REMOTE CONTROL RECEIVER How to set the clock Press button ¢fy for 3 seconds, the time indicator in the display keep flashing, press button ~j~ and ww.
To change bulbs: 1. 2. Switch off power and wait for 5 minute till the bulbs cool down. Wear gloves and remove the bulb by pulling side ward (as the direction instructed). Replace with 120V, GU, 50W halogen bulbs. CAUTION: 1. THE SURFACE OF THE HALOGEN BULBS MAY BE HOT. TAKE CARE WHEN TAKING THE REPLACEMENT. OIL cup 1. To install the oil cup, and lock it on to the motor blower. 2. The oil cup should be cleaned frequently. Tha oil accumulated inside the oil cup can not be more than half.
Warranty This product has been manufactured by Thor Group, 13831 Oaks Ave, Chung, California 2710. Thor Group disclaims all express warranties except for the following: This warranty applies to products purchased and located in the United States. Products purchased or located outside this area are excluded.