Warming Drawer Care & Use Manual (L30WD / L42CC-1)

10
L30WD/L42CC Use/Install Manual
Trouble Shooting Guide and Obtaining Service
1. Warming drawer will not heat up.
2. Heat on indicator light does not illuminate
1. Check if the unit is plugged in to an electrical outlet.
2. Check to ensure the GFCI has not been tripped.
3. Check if the temperature control dial is set properly.
4. Check if the circuit breaker has not been tripped
If Service is required: 1. Call Preferred Customer Service (888-289-5969)
2. Provide the following information:
Model Number
Serial Number
Date of Purchase
Name of the Dealer
Material Recommendations
Drawer interior (stainless steel) Use dish detergent. Wash, rinse well and dry. For hard water spots or scales, use
white vinegar. Apply with a sponge or cloth, rinse, and dry.
Heat Discoloration / Corrosion:
Clean with BarKeeper’s Friend® sprinked on a wet sponge or wet cloth. Apply to
stainless steel surface. Rub gently and evenly in the direction of the grain. Rinse and
dry.
Drawer exterior (stainless steel) Always wipe or rub in the direction of the grain. Clean with a soapy sponge, then rinse
and dry or use mild non-abrasive cleaners on a paper towel. Protect and polish with
stainless steel cleaner and a soft cloth. Remove water spots a cloth dampened with
white vinegar.
Control Panel Clean with hot soapy water or mild non-abrasive cleaner on a clean sponge. Wipe
clean. Avoid usng abrasive cleaners and scrubbing pads.
Cleaning Chart
Cleaning and Maintenance