Warming Drawer Care & Use Manual (L30WD / L42CC-1)

9
L30WD/L42CC Use/Install Manual
Cleaning and Maintenance
The Warming Drawer is made of welded stainless steel. It is non-rusting and non-magnetic.
1. Allow the warming drawer and its accessories to cool before cleaning.
2. Remove steam pans and all accessories from the warming drawer.
3. Unplug the warming drawer prior to cleaning.
4. Clean all items including the drawer with a mild cleanser. Scrub dirt with a sponge in the direction of the grain.
5. When cleaning the front panel, always scrub in the direction of the grain. In order to maintain the luster and highlights of
the polished surface, do not use abrasives when cleaning the polished surfaces.
6. Do not use steel wool to clean the drawer and accessories.
7. Check out the slide rails and make sure they are clean and free from debris.
8. It is recommended to clean the warming drawer after every use.
Lynx products are known for their attractive appearance. We achieve this by selecting only the finest grades of stainless
steel and applying exacting workmanship.
In order to maintain this attractive appearance over the life of the grill it is important to take the following steps:
Use a commercially available Stainless Steel cleaner* to clean and polish the exterior surfaces.
Doing these things on a regular basis minimizes the amount of e ort required.
Part of the appeal of your Lynx Accesory is the fine grain finish. When removing stubborn stains:
• Do not use metallic abrasives and always rub in the direction of the grain.
• Some household cleaning products are not suitable for stainless steel; be sure to read the label before using on your Lynx
Accesory.
• Always use the mildest cleaning solution first, scrubbing in the direction of the
grain. Specks of grease may gather in the grain of the stainless steel and bake
on to the surface, giving the appearance of rust. To remove these baked-on
foods use a fine to medium grit non-metallic abrasive pad (Scotch Brite is good)
in conjunction with a stainless steel cleaner.
• Solutions used for cleaning concrete and masonry can be very corrosive and will ‘attack’ stainless steel. Ensure your Lynx
products are well protected before you allow the use of such chemicals.
SPECIAL NOTE FOR LOCATIONS NEAR POOLS AND COASTAL AREAS:
The 304 stainless steel material used in the construction of a Lynx Grill is highly rust resistant, however, chlorine in the air
from swimming pools or the salt from sea air may cause surface rust to appear and even create some pitting if left on the
product.
Here are a few tips to avoid this:
• Regularly wipe down the exterior surfaces with a damp cloth. (Micro fiber cloths such as Ecloth perform very well).
• Allow the surfaces to dry before installing the cover. Do not cover a damp sink.
• In extreme environments apply a rust inhibitor which leaves a microscopic protective layer on the stainless. Products that
provide a layer of vapor corrosion inhibitors (VpCI™) protect the surface very well.
• For seasonal storage use the product referred to above, ensure the sink is dry and then cover and secure the cover to
minimize the amount of damp air getting to the surfaces.
THE LYNX LIMITED LIFE TIME WARRANTY PROVIDES PROTECTION AGAINST RUST THROUGH OF PARTS THAT
RENDER THE PRODUCT INOPERATIVE. IT DOES NOT COVER OCCASIONAL SURFACE RUST OR STAINING DUE TO
ENVIRONMENTAL CONDITIONS.
For light and heavy food stains there are many di erent stainless steel cleaners available.
Stainless Steel