User Manual
Lynx L15ICE 12
Start Up and Storage
L15ICE
WARNING:
Using air or carbon dioxide, drain the icemaker to prevent damage to the water supply line at subfreezing
temperatures. Shut o the icemaker unl proper air temperature is resumed.
1) Check that shipping tape(s), string and packing are removed before starng the icemaker.
2) Clean inside the storage bin and door.
3) Open the water supply line shut-o valve and plug in the icemaker.
4) Move the control switch to the ICE” posion.
1) Close the water supply line shut-o valve, and open the
drain valve.
2) Move the control switch to the “OFF” posion.
3) Blow out the water supply line and the internal water
circuit.
4) Unplug the icemaker.
Note: This procedure is necessary to protect the ice
maker from freezing up at subfreezing temperatures.
5) Remove all ice from the storage bin, and clean the bin.
6) Remove the front kick-plate
7) Clean the condenser and all parts of loose debris that may
have accumulated like dirt, dust and leaves.
8) Reinstall the kick-plate.
9) Close the water supply line shut-o valve and open the drain
line.
10) Close the drain valve.
Preparing for Long Storage
(Winterizing)
This should be done when the daily low
temperatures fall below freezing. It is best
to winterize before the low temperatures
begin. Operating this appliance at freezing
temperature will void the warranty.