User Manual
Lynx L15ICE 13
Cleaning and Care Procedures
L15ICE
The cleaning process will remove lime deposits from the water system.
1) Remove all ice from the evaporator and the storage bin.
Note: To remove cubes on the evaporator, move the
control switch to the "OFF" posion
and move it back to the "ICE" posion aer 3 minutes.
The defrost cycle starts
and the cubes will be removed from the evaporator.
2) Move the control switch to the "OFF" posion. Close
the water supply line shut-o valve.
3) Disconnect the sucon tube by
compressing both plasc tabs to unlock the
joint in the direcon of the black arrows and
pulling the tube clear.
4) Spread out the tabs on both sides of the
water tank to unlock it, then pull it out
toward you. Drain the tank.
5) Aer draining, slide in the water tank along
the rails at the boom of the right and le
brackets unl it clicks into place.
6) Ret the sucon tube onto the water tank
inlet by pushing the joint to lock it securely
in the direcon of the arrows. A loose ng
may cause a water leak.
7) Slowly pour the cleaning soluon into the water tank.
8) Move the control switch to the "WASH" posion.
9) Aer circulang the cleaning soluon for about 30
minutes, move the control switch to
the "OFF" posion.
10) Remove the water tank, drain it, and replace it as described in 3) through 6).
11) Open the water supply line shut-o valve.