User Manual
Lynx L15ICE 14
12) Move the control switch to the "WASH" posion to circulate clean water for about 5 minutes.
13) Move the control switch to the "OFF" posion, then remove the water tank, drain it, and replace it as described
in 3) through 6).
14) Repeat 12) and 13) three more mes to rinse thoroughly.
Sanizing Soluon
Dilute 0.5 . oz. (14.8 ml or 1 tbs) of 5.25% sodium hypochlorite soluon (chlorine
bleach) with 1 gallon (3.8 l) of warm water. Using a chlorine test strip or other method,
conrm that you have a concentraon of about 200 ppm.
Sanizing Procedure
The sanizing process will sanize the icemaker.
1) Move the control switch to the "OFF" posion.
2) Open the bin door and remove ice from the
storage bin.
3) Remove the slope by bending its center
carefully and releasing it from the two slope
shas. Remove the slope from the storage bin.
4) Thoroughly clean and sanize the storage
bin, slope, scoop and any parts normally
accessible from the storage bin.
5) Remove each separator by liing it to the
horizontal posion and pushing it hard
inward. Remove all separators in the same
way and clean and sanize them.
6) Disconnect the sucon tube by
compressing both plasc tabs to unlock the
joint in the direcon of the black arrows and
pulling the tube clear to drain the tank.
IMPORTANT
For safety and maximum eecveness, use the soluon immediately aer diluon.
Cleaning and Care Procedures
L15ICE