User Manual
Lynx L15ICE 15
Cleaning and Care Procedures
L15ICE
7) Spread out the tabs on both sides to unlock the water tank, and
pull it out toward you. Soak the water tank in the sanizing
soluon for 10 minutes.
8) Li o the ice chute from the front frame pipe and then from the
rear frame pipe. Soak the ice chute in the sanizing soluon for
10 minutes.
9) Pull the discharge tube from the spray assembly. Remove the
assembly by pulling it toward you.
10) Remove the two caps. Soak the caps and the spray assembly in the
sanizing soluon for 10 minutes. If the nozzles are clogged, clean
them with a wire or a suitable brush.
11) Ret the two caps in their correct posions. Make sure the reducing pipe is
in place in the center.
12) Slide in the spray assembly along the rails on the right and
le brackets. Ret the discharge tube securely on the spray
assembly. A loose ng may cause a water leak.