User Manual
Lynx L15ICE 17
23) Disconnect the sucon tube by
compressing both plasc tabs to unlock the
joint in the direcon of the black arrows and pulling the
tube clear.
24) Spread out the tabs on both sides of the water
tank to unlock it, then pull it out toward you. Drain
the tank.
25) Aer draining, slide in the water tank along the
rails at the boom of the right and le brackets unl it
clicks into place.
26) Ret the sucon tube onto the water tank inlet by pushing
the joint to lock it securely in the direcon of the arrows. A
loose ng may cause a water leak.
27) Repeat 20) through 26) one me.
28) Open the water supply line shut-o valve.
29) Move the control switch to the "WASH" posion
to circulate clean water for about 5 minutes.
30) Move the control switch to the “OFF" posion, then remove
the water tank, drain it, a replace it as described in 23)
through 26).
31) Repeat 29) and 30) two more mes to rinse thoroughly.
32) Move the control switch to the "ICE" posion, and start the
automac ice making process.
20) Mix a new batch of the sanizing soluon and slowly pour it into the water tank.
21) Move the control switch to the "WASH" posion.
22) Aer circulang the sanizing soluon for about 15 minutes, move the control switch the "OFF" posi-
on.
Cleaning and Care Procedures
L15ICE