User Manual
Lynx L15ICE 7
Connecon to AC:
Installaon requires an outdoor 120 VAC, 15 amp dedicated GFI protected outlet.
The warming drawer is rated as follows; 120 VAC, 60 Hz, 480 W, 4 AMP
RECOMMENDED GROUNDING METHOD
1. Place the appliance in a dry and regularly venlated place. Never place the appliance near heat eming devices
(e.g. grills, radiator, water heater or similar devices).
2. Avoid locang the ice machine where dripping is not desirable.
3. The ice machine requires no clearance on either side. But allow enough space at the rear for water supply and
drain connecons and at least 15” clearance at the front.
A 115 Volt, 60 Hz. AC only 15- or 20- amp fused or circuit breaker protected, grounded electrical supply is required. It is
recommended that a separate circuit serving only your appliance be provided. Use outlets that cannot be turned o by
a switch or pull chain. Connect this appliance to a 3 prong power supply socket outlet (which has a ground terminal). If
you only have a two prong outlet have it replaced by a qualied technician with an outlet that meets the local codes.
Required nominal voltage and frequency are indicated on the rang plate. The connecon to the power supply and
grounding has to be made according to current standards and regulaons. The appliance resists temporary voltage
tolerance from -15 to 10%.
IMPORTANT
Electrical Shock Hazard. Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use a 2/3
adapter. Do not use an extension cord. Failure to follow these instrucons can result in death, re, or electrical
shock.
1. Ensure refrigerant lines do not touch or rub lines or other surfaces
2. Remove all protecve plasc lm from panels. It the icemaker has been exposed to sun or heat, remove the lm
only aer the icemaker has cooled.
3. Clean the interior with soap and water and rinse thoroughly
ENERGY SAVING TIPS
1. The more airow you can provide around an appliance, the less energy it will use.
2. Keep doors or drawers open a minimum of me, and shut securely.
LEVELING YOUR ICE MACHINE
1. Locate the two front leveling legs mounted into the underside of the appliance.
2. Install on a rm foundaon and adjust the front legs just enough to li the cabinet up o of the oor.
3. Place a leveling tool on top of the appliance rst side to side, then front to back. Turn leg counterclockwise to raise
a corner. Turn leg clockwise to lower a corner.
Installaon Instrucons
L15ICE