Pan and Tilt Assembly Guide

Lynx B - Pan and Tilt Assembly

Instructions Rev. 1.

Image of Pan and Tilt without camera.

Step 1.

If necessary, drill the servo horns

with the 1/16" drill in the indicated

positions. These holes are by the 2

and the 4 molded on the horn. Do

this to both the servos.

Figure 1.

PAGE 1
Lynx B - Pan and Tilt Assembly Instructions Rev. 1. Image of Pan and Tilt without camera. Step 1. If necessary, drill the servo horns with the 1/16" drill in the indicated positions. These holes are by the 2 and the 4 molded on the horn. Do this to both the servos. Figure 1.
PAGE 2
Step 2. Attach the multi-purpose servo bracket to one servo as pictured. 2x Figure 2. Step 3. Attach the "C" servo bracket to the multi-purpose bracket as shown. Push the button head screw through the multi-purpose bracket, and add a nylon washer. Put the "C" bracket on the screw, and secure it with the nylon acorn nut. Don't make this too tight! 1x 1x 1x Figure 3.
PAGE 3
Step 4. Install the servo into the multipurpose bracket. Use four push-in fasteners. 4x Figure 4. Step 5. Attach the "C" bracket to the servo as pictured. 2x Figure 5. Step 6. Any small CCD camera can be attached to the Pan and Tilt assembly. The mounting plate is 2.0" wide by 1.0" high, and the entire surface can be used. The camera can be attached with double sided tape. Figure 6.