Specifications

5
The DiO 2448 Adapter Card
1. Coaxial S/PDIF Input: This RCA connector receives a S/PDIF stereo
signal from an external coaxial S/PDIF device.
2. Coaxial S/PDIF Output: This RCA connector transmits a S/PDIF stereo
signal to an external coaxial S/PDIF device.
3. Optical S/PDIF Input: This TOSlink connector receives an optical
S/PDIF stereo signal from an external optical S/PDIF device.
4. Optical S/PDIF Output: This TOSlink connector transmits an optical
S/PDIF stereo signal to an external optical S/PDIF device.
5. Analog Audio Outputs (Left & Right): These RCA connectors carry the
left and right line-level signals to an external monitoring or mix-down
device. The signal levels of these outputs are compatible with most
consumer gear.
6. Internal CD-ROM headers, Analog: These headers (connectors) accept
analog line-level audio from a CD-ROM player or similar source internal
to the computer. Only one of these headers may be in use at one time.
7. Internal CD-ROM header, Digital: This header (connector) accepts a
digital audio S/PDIF signal from a CD-ROM player or similar source
internal to the computer. This header is wired in parallel to the coaxial
S/PDIF input. Therefore only one of these connectors may be used at a
time.
Quick Guide to Getting Started
Here is a list of the steps required to get your DiO 2448 up and running:
1. Physically install the card in your computer (see ‘Hardware
Installation’).
2. Start Windows and allow Windows’ Plug-and-Play to prompt you for
the DiO 2448 drivers via the Add New Hardware wizard.
3. Install drivers and support software (see ‘Driver & Software
Installation’).
4. Configure your digital recording software to select the DiO 2448 ports as
its active audio input and output devices (see ‘Using DiO 2448 with
Software Applications’ and also your applications software manual).
5. Hook your digital audio gear up to the DiO 2448 (see ‘Typical DiO 2448
Setup’).