Manual

Internal Jumper Settings

There are four configuration jumpers inside the Flying Calf chas-

sis. Typically you will never need to open the Flying Calf and

adjust these jumpers. For some applications, however, it may be

required. JP2 and JP3 are used to set the input levels for the left

and right channels. JP1 consists of two jumpers which are used to

set the copy-protect status of the Flying Calf.

IMPORTANT: Always power off the Flying Calf and discon-

nect the power adapter before removing its top.

Location of Internal Jumpers - Fig. 3

Input Level Jumpers

The Flying Calf A/D factory settings will accommodate audio sig-

nals from most line-level devices (which typically have a nominal

signal level of -10 dBV). However, some consumer gear is not

capable of producing enough signal gain to drive the Flying Calf

to full-scale. Therefore, the Calf has internal jumpers which may

be individually set to compensate for these "weaker" devices.

JP1

JP2

JP3

Jumpers JP3 & JP2

Jumper JP1