User manual

ENGLISH
VYSYS XDC-20
ADDITIONAL WIRELESS DOME CAMERA
16
Installation and Commissioning
• If necessary, the camera must be aligned
correctly so that the desired vision frame can
be monitored. The IR-LEDs are activated
automatically during darkness. However, the
LEDs are not visible to the human eye.
Note that at night the image is not shown
in colour, but instead in black/white, on a
connected monitor.
Please also note the instructions of the
VYSYS WIRELESS NVR when the camera
integrated into the system.
TROUBLESHOOTING
No camera image ?
• Set the correct input channel on the monitor.
• Check the voltage/current supply to the camera.
• Check the cable connections of the camera.
• Check the wireless reception of the camera.
Image too bright ?
• Check the settings in the Setup menu,
if necessary, reset the camera to the
factory settings.
• Do not point the camera towards the sun
or a light.
• Choose corresponding settings in the Setup
menu, e.g. for the white balance etc.
Only black/white camera image ?
• The camera automatically switches over to a
black/white image at night (the IR-LEDs are
activated at the same time). A colour display
is not possible here.