Operation Manual

34
Installing the machine
Positioning the machine
When determining the place to put your ma-
chine on, take care to choose a place where you
can easily load and unload your dishes.
Do not put your machine in any location where
there is the probability for the room tempera-
ture to fall below 0°C.
Before positioning, take the machine out of its
packaging by following the warnings located on
the package.
Position the machine close to a water tap or
drain. You need to site your machine, taking
into consideration that its connections will not
be altered once they are made.
Do not grip the machine by its door or panel in
order to move it.
Take care to leave a certain clearance from all
sides of the machine so that you can comforta-
bly move it back and forth during cleaning.
Make sure that the water inlet and outlet ho-
ses do not get squeezed while positioning the
machine.
Also, make sure that the machine does not
stand on the electrical cable.
Adjust the machine’s adjustable feet so that it
can stand level and balanced. Proper positio-
ning of the machine ensures problem-free ope-
ning and closing of its door.
If the door of your machine does not close pro-
perly, check if the machine is stable on the floor
it stands; if not, adjust the adjustable feet and
ensure its stable position.
Water connection
Be sure that the indoor plumbing is suitable for
installing a dishwasher. Also, we recommend
that you fit a filter at the entrance of your place
or apartment so as to avoid any damage to
your machine because of any contamination
(sand, clay, rust etc.) that might be occasion-
ally carried in through the mains water supply
or the indoor plumbing, and to forestall such
complaints as yellowing and formation of depo-
sits after washing.
Water inlet hose
Do not use the water
inlet hose of your old
machine, if any. Use the
new water inlet hose
supplied with your ma-
chine instead. If you are
going to connect a new
or long-unused water in-
let hose to your machine,
run water through it for a while before making
the connection. Connect the water inlet hose
directly to the water inlet tap. The pressure
supplied by the tap should be at a minimumof
0.03 Mpa and and at a maximum of 1 Mpa. If
the water pressure is above 1 Mpa, a pressu-
re-relief valve should be fitted in between.
After the connections are made, the tap should
be turned on fully and checked for water tight-
ness.
For the safety of your machine, make sure to
always turn off the water inlet tap after each
wash programme is finished.
NOTE: Aquastop water spout is used in some
models. In case of using Aquastop, a dange-
rous tension exists. Do not cut Aquastop water
spout. Do not let it get folded or twisted.