Operation Manual
48
Spray arms
Check whether or not the holes for the upper
and lower spray arms are clogged. If there is
any clogging, remove the spray arms and clean
them under water.
You can remove the lower spray arm by pulling
it upwards, while the upper spray arm nut can
be removed by turning the nut to the left.
Be sure that the nut is perfectly tightened
when refitting the upper spray arm.
Hose filter
Water is prevented by the inlet hose filter so
as to avoid any damage to your machine becau-
se of any contamination (sand, clay, rust etc.)
that might be occasionally carried in through
the mains water supply or the indoor plumbing,
and to forestall such complaints as yellowing
and formation of deposits after washing. Check
the filter and the hose from time to time and
clean them if necessary. To clean the filter, first
turn off your tap and then remove the hose.
After removing the filter from the hose, clean
it under the tap. Insert the cleaned filter back
into its place inside the hose. Ret the hose.