Owner's Manual

8
CR-XBT Multimedia Monitors
CR-XBT Multimedia Monitors
5. Powered Speaker Position Select Switch
Here you get to decide if the powered monitor
is to be positioned on the lef side (switch up)
or right side (switch down) of the desk.
One convenience is that it keeps the power cord,
front and/or rear panel connections from crossing
your work space. Additionally, it doesn’t discriminate
between right or lef-handed users. Simply set it up
to suit your preference.
6. Wire Terminals (±)
Connect the included black (–)
and red (+) speaker wires from
the powered monitor’s ± spring
clips [big green ball number 6 on
the previous page] to the passive
monitor’s ± spring clips (as seen
to the right).
7. Custom-Tuned Rear Port
The custom-tuned rear port uses the radiation from
the rear of the woofer cone to extend the low-frequency
response of the speaker. The size of the port is carefully
designed with respect to the volume of the cabinet
and the characteristics of the woofer to produce
low-frequency extension.
6
CR-XBT: Front Panel Features
8. Phones Output
This /8" TRS connector supplies the output to stereo
headphones. The volume is controlled with the volume
knob. The signal to the power amp is killed when
headphones are connected.
The phones output is wired as follows, according
to standards specified by the AES (Audio Engineering
Society):
Stereo /8" TRS
Sleeve = Shield (Ground)
Tip = Lef Channel
Ring = Right Channel
Warning: The headphone amp is loud and
could cause permanent hearing damage.
Even intermediate levels may be painfully
loud with some headphones. BE CAREFUL!
Always turn the volume knob all the way down before
connecting headphones. Then turn it up slowly as you
listen carefully.
9. Volume Knob
CR-XBT Series multimedia monitors expect
a line-level signal at its input. Use this control
to adjust the sensitivity of the input section
according to the signal strength at its input.
The volume knob not only adjusts the overall output
level, but it also turns the monitor on and o. Simply
turn the knob counter-clockwise until it “clicks” o.
Turn the knob clockwise to turn the volume up.
Refer to the Quick Start section on page 4 for the
level-setting procedure.
0. Running Man Bluetooth Button / LED
The ring surrounding the Running Man logo
on the front panel illuminates white when the CR-XBT
multimedia monitor is plugged into an AC outlet,
the power switch is turned on and the front panel
volume control is turned clockwise until the monitor
“clicks” on.
The logo isn’t just for pretty looks and LED
illumination... it’s also how to connect your device
to the monitor via Bluetooth! Read on...
Upon powering up the CR-XBT, the Bluetooth function
is either:
() In sleep mode. See ‘Pairing and connecting
for the first time’ (next page) or...
(2) ...Paired and connected. See ‘Previously paired
and connected devices’ (next page).
SEASON
SUMMER
SPRING
FALLWINTER
8
9
10
11