User Manual

Owner’s Manual
13
Owner’s Manual
Appendix A: Service Information
Poor sound
• Isitloudanddistorted?Makesurethatyou’renot
  overdrivingastageinthesignalchain.Verifythat
  alllevelcontrolsaresetproperly.
• Istheinputconnectorpluggedcompletelyinto
  thejack?Besureallconnectionsaresecure.
Noise
• Makesureallconnectionstotheactive 
loudspeakersaregoodandsound.
• Makesurenoneofthesignalcablesarerouted
  nearACcables,powertransformers,orother
  EMI-inducingdevices.
• IstherealightdimmerorotherSCR-based
  deviceonthesameACcircuitastheThump 
loudspeaker?UseanAClinelterorplugthe
loudspeakerintoadifferentACcircuit.
Hum
• Trydisconnectingthecableconnectedtothe
  inputjack.Ifthenoisedisappears,itcouldbe
  a“groundloop,”ratherthanaproblemwiththe
  Thumploudspeaker.Trysomeofthefollowing
  troubleshootingideas:
• Usebalancedconnectionsthroughoutyoursystem
  forthebestnoiserejection.
• Wheneverpossible,plugalltheaudioequipment’s
  linecordsintooutletswhichshareacommon
  ground.Thedistancebetweentheoutletsandthe
  commongroundshouldbeasshortaspossible.
Repair
Forwarrantyservice,refertothewarranty
informationonpage19.
Non-warrantyserviceisavailableatafactory-
authorizedservicecenter.Tolocatethenearest
servicecenter,visitwww.720trees.com,click“Contact
TechSupport”andselect“LocateaServiceCenter
orDistributor”[3].ServiceforThumploudspeakers
outsidetheUnitedStatescanbeobtainedthroughlocal
dealersordistributors.
Ifyoudonothaveaccesstoourwebsite,youmaycall
theTechSupportdepartmentat1-800-898-3211,
Monday-Friday,duringnormalbusinesshours,Pacic
Time,toexplaintheproblem.TechSupportwilltellyou
wherethenearestfactory-authorizedservicecenteris
locatedinyourarea.
IfyouthinkyourThumploudspeakerhasaproblem,
pleasecheckoutthefollowingtroubleshootingtipsand
doyourbesttoconrmtheproblem.VisittheSupport
sectionofourwebsite(www.720trees.com)whereyou
willndlotsofusefulinformationsuchasFAQsand
otherdocumentation.Youmayndtheanswertothe
problemwithouthavingtopartwithyoursubwoofer.
Troubleshooting
No power
• Ourfavoritequestion:Isitpluggedin?Makesure
  theACoutletislive[checkwithatesterorlamp].
• Ournextfavoritequestion:Isthepowerswitch
  on?Ifnot,tryturningiton.
• Makesurethelinecordissecurelyseatedinthe
  linecordsocketandpluggedallthewayintothe
  ACoutlet.
• IsthepowerLEDonthefrontandrearpanel
  illuminated?Ifnot,makesuretheACoutlet
  islive.Ifso,referto“Nosound”below.
• TheinternalAClinefusemaybeblown.Thisis
  notauserserviceablepart.Ifyoususpectthe
  AClinefuseisblown,pleaseseethe"Repair"
  sectionnext.
No sound
• Isthelevelknobfortheinputsourceturnedall
  thewaydown?Verifythatallthevolumecontrols
  inthesystemareproperlyadjusted.Lookatthe
  levelmetertoensurethatthemixerisreceiving
  asignal.
• Isthesignalsourceworking?Makesurethe 
  connectingcablesareingoodrepairandsecurely
  connectedatbothends.Makesuretheoutput
  levelcontrolonthemixingconsoleisturnedup
  sufcientlytodrivetheinputsofthespeaker.
• Makesurethemixerdoesnothaveamuteonora
  processorloopengaged.Ifyoundsomethinglike
  this,makesurethelevelisturneddownbefore
  disengagingtheoffendingswitch.
• Hasitshutdown?Makesurethereisatleast
  sixinchesoffreespacebehindeachThump 
loudspeaker.