User guide

Safety Information
Before starting your Mvisto, please carefully read the following information relating to the
safety issues on your device in order to extend its life.
Power on/off precautions
Mvisto Remote Control provides the POWER ON/OFF button that controls the power status
of your device. It is highly recommended to switch the unit to standby mode (yellow
light) when it is not in use.
Switching Mvisto to stand-by will change the Mvisto indication LED from GREEN to
YELLOW, the HDD to stand-by mode, and the entire system will consume less power. As a
result, less heat is produced and much less mechanical stress is caused to the HDD. All the
above recommendations, if followed, will extend the life for your Mvisto.
Location and placing precautions
Do not place any other objects on top of the unit. Do not place the unit on an amplifier or
other equipment that can become hot.
Avoid positioning your Mvisto device in the following places:
• Locations with direct sunlight, next to radiators, other sources of heat, or in vehicles
that are parked directly in the sun with the windows and doors closed.
• Locations with very high temperature (more than 35° C) or humidity (more than 90%).
• Dusty locations.
• Locations subject to vibration, shock, or with a sloping base.
Electricity and power plug
Careful attention must be paid to the following points in order to avoid operational faults with
the equipment and to prevent electric shock, fire, and injury:
• When removing the power cable from the socket, always pull on the plug and never
on the cable.
 Do not connect and remove the power cable with wet hands.
 Keep the power cable away from heaters.
 Never try to repair the power cable yourself or to modify it in any way.
 Clean dust, dirt, and etc. from the power plug at regular intervals.
 If the unit is dropped or becomes damaged in any other way, unplug the power cable.
 If the unit should emit smoke, unusual smell, or noise, switch it off and unplug the
power cable. In such cases, please contact your dealer.
 If the unit is not used for extended periods, then the power plug should be
removed from the socket.
Cables
Use only the cables supplied or recommended by your vendor in order to avoid the
risk of malfunction, electric shock, and possible interference of the device.
■
19