Operation Manual

- 17 -
Calibration
When the touch operation is not sensitive or valid, you should
calibrate the touch screen using the calibration setting function.
Adjust the response positions of the touch panel as followings:
1. Touch [ Start ] to enter.
2. Touch [ Cancel ] to exit.
3. Press and hold the center of [ + ] for 2 seconds, the [ + ] will move
automatically.
4. Aim at center of [ + ], follow the path as shown in the figure. Once
steps 1-5 are complete, touch [ OK ] to exit calibrating mode.
SWC Programing
The following controls are available for most vehicles:
1 2 3 4 5 6
Volume + Volume - Mute Next Prev Play
7 8 9 10 11 12
Home Preset + Preset - Band Source Answer
Touch [ Enter ], the SWC menu will display.
Up to 12 steering wheel control functions can be programmed via the built-in SWC interface. Not
all functions may be supported for each vehicle.
1. Before programming, you need to clear / reset the SWC interface by pressing the [Reset] icon.
2. Define the functions of the steering wheel controls by pressing a number 1 ~ 12, then press a
function between the available ones. A check mark corresponding to the number and function
will be displayed. Repeat the confusion until completing all the steering wheel control functions.
Settings
Note:
Functions 1 ~ 12 must be assigned to a function on
the OE steering wheel. For example, if the OE steering
wheel does not support Preset + and Preset -, then
these functions must be cleared / reset in order for the
other functions to work correctly.
3. To “learn” the programming completed in step 2 above, touch the [ Program ] icon. You will then
be prompted to push each button on the OE steering wheel (for 1 second), so the unit can learn
the corresponding function.
4. SWC learning / programming is now complete.
5. Touch [
] to exit.