User`s manual

Setting Up the XRouter Pro Through a Web Browser

Now that you have finished configuring the TCP/IP addresses of

the client and managing computers, you can begin configuring the

XRouter Pro’s Internet settings. This can be done through a standard

Web browser (such as Netscape Navigator, Netscape Communicator,

or Microsoft Internet Explorer).

IMPORTANT: Before following the instructions below you must find

out if your ISP is providing one of following IP addressing types:

Dynamic with PPPoE - If your service is dynamic addressing with

PPPoE support, you do not need to follow the instructions below.

However,you will need to proceed to the “PPPoE Settings” section in

the Advanced Configuration section of this manual.

Dynamic - If your service is dynamic, you do not need to follow the

instructions below because the XRouter Pro automatically configures

the TCP/IP information provided by your ISP and you should already

have Internet access. If this is the case, you are done installing the

XRouter Pro and can begin accessing the Internet from any of the

client computers.

(Note: Some ISPs require the use of a MAC address (hardware

address of a network device) to connect to their service. If this is the

case, you will need to contact to your service provider and give them

the Public MAC address of your XRouter Pro. The Public MAC

address of your XRouter Pro can be found on the OnePage Setup of

the XRouter Pro. To access the XRouter Pro’s OnePage Setup

screen, follow the instructions below.)

Static with PPPoE - if your ISP has provided a static IP address or if

you would like to make further changes to the advanced features, you

will need to enter the Web-based configuration described below to

configure the static IP address provided by your ISP. You will also

need to use the “PPPoE Settings” section in Advanced Configuration

section of this manual.

Static - if your ISP has provided a static IP address or if you would

like to make further changes to the advanced features, you will need to

enter the Web-based configuration described below to configure the

static IP address provided by your ISP .

Easy Installation