User`s manual

Static Routing
The Static routing feature of the XRouter Pro allows the LAN to
communicate with another router on the LAN and with their respective
LAN segment. By setting up static routes, computers on the XRouter
Pro’s immediate LAN may utilize another router’s LAN and at the time
allow the other router’s LAN to utilize the XRouter’s Pro LAN. See the
example below for the setup of a Static route.
To achieve the static route in the example above, the following infor-
mation would be inputted into the Static Routing page of the XRouter
Pro:
Static Routing: 1--
Destination LAN IP: 192.168.2.0
Subnet: 255.255.255.0
Default Gateway: 192.168.1.3
Hop Count: 1
Interface: LAN
In the example above, PC-1 would have access to LAN#1, LAN#2 and
the Internet. Where as, PC-2 would have access to LAN#1 and
LAN#2, but not the Internet. In order for PC-2 to have Internet
access, a second XRouter Pro or another router with static routing
capabilities would need to be used and configured.
Static Routing is considered an advanced feature and is not
required for basic configuration of the XRouter Pro.
Advanced Configuration
23
MIH-130
Router
LAN #2
192.168.2.0
LAN #1
192.168.1.0
PC-2
PC-1
IP: 192.168.1.99
Default Gateway: 192.168.1.1
192.168.2.4
192.168.1.3
IP: 192.168.2.100
Default Gateway: 192.168.2.4
Internet