User's Manual

¥ Bus Width: 32 bits
¥ Power: 3.3 V
¥ Temperature: 0ûC~60ûC/ 32ûF~140ûF (Std. Operating)
¥ Humidity: 10% to 90%
¥ Distance: 100m from Hub to Node
¥ Dimensions: 86mm x 54mm x 5 mm
Installing the Fast Ethernet CardBus Card
You will be installing the Fast Ethernet CardBus Card in your computer. If you are
having trouble locating the slot, refer to the user's manual of your computer or consult the
manufacture of your computer.
Gently slide the PC Card into the CardBus PC Card slot. Make sure the Card is firmly
seated in the socket and you are ready to setup and install the network drivers.
For a connection to a Fast Ethernet network, use a Category 5 unshielded twisted pair
(UTP-5) or Category 1 shielded twisted pair (STP-1) cable with a RJ-45 connector to
connect with a 100Mbps port of hub or switch.
For a connection to a 10BASE-T Ethernet network, use a Category 3,4 or 5 (UTP) or
(STP) 1 cable with a RJ-45 connector to connect with a 10Mbps port of a hub or switch.
Introduction
2