User guide

Installation
MultiView™ II DVI-Tx Installation and User Guide 10
To install the MVII-DVI-Rx-1K receiver:
1. Connect the DVI OUT connector to the display.
2. Connect any audio and/or serial cables to the (AUX I/O) and (IOIO) connectors, depending on the
specific model of receiver you are installing. Please refer to the –A, -S or –SAP option descriptions for
more information.
3. Connect the twisted-pair cable from a MultiView-II™ DVI-Tx transmitter to the LINK INPUT connector
on the receiver.
4. If you are daisy-chaining multiple receivers, also connect the downstream twisted-pair cable to the
LINK OUTPUT port on the receiver.
5. Connect the DC power cable to the POWER port, and check for the following indicators:
 The power-on LED should light up (Green).
 The CFG indicator is off.
 The SKEW/RGB indicator is off.
 The EQ/SKEW indicators display the current EQ settings (0 to 100%).
6. IMPORTANT: The MVII-DVI-Rx-1K will auto-adjust the EQ and Skew settings. This is
the factory-default behavior. However, in some applications it will be necessary to
manually fine-tune these adjustments, or leave it in manual-adjust mode after the
initial setup.
7. When the EQ and SKEW settings are properly adjusted, the video should appear on the display (make sure
display is powered ON).
8. Make any other required configuration changes via the LED/button user-interface.
It is critical that the EQ and SKEW settings be adjusted to compensate for the length of the
twisted-pair cable leading back to the transmitter.
Figure 4: MVII-DVI-Rx-1K Receiver connections
 (Optional) Connect the
output twisted-pair cable
via the LINK OUTPUT port.
 Connect the video out
DVI connector to the
display device.
 Connect the DC power
cable (+5VDC @ 2.6A.
max) to the POWER port.
 Connect the twisted-pair
cable via the LINK INPUT
port.
 (Optional) Make your serial and/or audio
connections via the DB9 IOIO or AUX I/O
connectors, as appropriate. Refer to –A, -S
and -SAP option descriptions.