User guide

Installation
MultiView™ II DVI-Tx Installation and User Guide 14
5.7.1 Sync Settings
The DVI-Tx supports the complete set of MultiView sync modes:
 RepliSync-I, RespliSync-Ia (normal/stretched): Generally needed for legacy MultiView receivers.
 RepliSync-II: Required for newer MultiView-II receivers.
 Auto-detect RSI/RSIa: The DVI-Tx will automatically select RepliSync-I or RepliSync-II, depending on
video format.
 Fixed-Sync: Necessary for some legacy receivers and VGA displays.
Note that Fixed-sync is the factory-default setting, and is required when connecting to the
companion MVII-DVI-Rx-1K receiver.
Note that any connected MultiView™ receiver should generally be set to the same sync-mode and may require
other configuration adjustments (such as sync-polarity when using fixed-sync). Otherwise, you may not get a
proper video display output at that receiver, or none at all.
Perform the procedure below while the transmitter is in the normal operating state (CFG indicator is off):
 Press and release the CFG button once to access configuration-mode (CFG indicator = on).
 Press and release the SEL button once. You will now be able to change sync-mode settings.
 LED indicators 1-3 should be illuminated (either DIM or ON); all others (indicators 4-8) should be off.
 Press the CFG button repeatedly to step through the available sync-mode settings as shown below.
 To leave configuration-mode step through all the options OR leave the buttons untouched for 10
seconds.
LED1
LED2
LED3
Front Panel View
Sync-mode Setting
dim
dim
dim
The DVI-Tx will auto-detect the required RepliSync-I
mode (“normal” or “stretched”).
dim
dim
ON
Force RepliSync-I normal Horizontal sync. pulse
encoding.
dim
ON
dim
Force RepliSync-I “stretched” Horizontal sync. pulse
encoding.
dim
ON
ON
Force RepliSync-II (only compatible with MVII type
analog receivers).
ON
dim
dim
Force fixed-sync mode.
NOTE: All connected MultiView receivers must also be
in fixed-sync mode and with the appropriate H/V
polarities selected.
This is the factory-default setting, and this is the
required mode when interfacing to a MultiView-II
DVI-Rx-1K receiver.