User guide

Specifications
MultiView™ II DVI-Tx Installation and User Guide 1
Chapter 1 Specifications
The following table lists the general specifications of the MVII-DVI-Tx.
Table 1: MVII-DVI-Tx General Specifications
Item
Description
UTP Cable Required
4 twisted-pair “FTP” type cable is recommended for performance and EMC compliance.
Regular or minimized-skew type is acceptable.
Supported Video
Formats
VESA and CEA video formats, input on a digital DVI-D connector.
Supported video formats include 1080p/60/24. Refer to Appendix-A for a full list of
supported resolutions.
Audio Signals
(A) Mode: Supports L+R summed audio input, 47K ohms input impedance. A source
device with 600 ohms maximum output impedance is recommended.
(S/PDIF mode): For S/PDIF digital-audio, 75 Ohm (typical input impedance).
Note: The DVI-Tx (transmitter) can also de-embed 2CH-PCM digital audio, which can be
extracted as a S/PDIF digital audio stream at the receiver.
Serial Characteristics
(S) mode: Protocol: Asynchronous; transparent to data format; transparent to data rates
up to 115 kbps; simplex.
(SAP) model: Protocol: Asynchronous; 9 fixed baud rates are supported, refer to SAP-II
Programming Manual for additional details
Connectors
(2) DVI-D (F) (Video in/out)
(1) 4 pin phoenix (Auxiliary signal input)
(1) RJ-45 (FTP link output)
(1) DB9F (only if the SAP option module is installed)
(1) DC power jack
Temperature/Humidity
Tolerance
Operating: 32 to 104°F (0 to 40°C), 10% to 80% RH non-condensing.
Storage: -4 to +140°F (-20 to +60°C), 10% to 80% RH non-condensing.
Enclosure
Steel, black powder-coat finish.
Power
Input voltage: +5 VDC @ 1.2 Amps max.
Consumption: 6 watts maximum
Size
1.2"H x 4.2"W x 4.3"D (3.0 x 10.4 x 10.9 cm)
Weight
1 lb. (0.45 kg)
1.1 DVI Interface
The DVI interfaces (video-in and local video-out) have the following characteristics:
Item
Description
Video Support
VESA and CEA video formats, input on a digital DVI-D connector.
Supported video formats include 1080p/60/24. Refer to Appendix-A for a full list of
supported resolutions.
Video output formats (local output port): The local port is essentially a direct copy of
the video input port.
Video Connectors
(1) DVI-D input connector, (1) DVI-D output connector.
Audio
Characteristics
There is a 4
th
-pair configuration setting which allow de-embedding of 2CH-PCM digital
audio. The digital audio is sent on the 4
th
-pair as a SPDIF digital audio stream.
EDID/DDC
This module supports the EDID/DDC connections on the DVI-D input connector.
HDMI
It is usually possible to connect to HDMI devices (via a plug-adapter or cable-adapter)
if the source device is providing un-protected content only (non-HDCP). Embedded
HDMI audio is supported.
HDCP
Not supported, even if a “HDMI-to-DVI” plug-adapter or cable-adapter is used.
CEC
Not supported, even if a “HDMI-to-DVI” plug-adapter or cable-adapter is used.