Specifications

V housing with straps (not supplied). Figure 3 shows the transceiver mounted to
the LAR V berglass shell.
3.5.3 LAR V ADAPTER: If a LAR V Adapter is used instead of a full-face
or mouth mask, install the adapter between the dive surface valve (DSV)/T-bit
assembly and the inhalation hose. See the instruction sheet provided with the LAR
V Adapter for more information.
3.6 PRE-DIVE CHECKLIST
l. Fully charged RB-14 NiMH battery pack installed (Section 4).
2. O-rings in place, clamps secure.
3. Diver unit in place with transducer free of diving equipment.
4. Earphone(s) adjusted and in position.
5. Hi-Use
®
connector lightly greased and properly mated.
6. Microphone is tightly secured by screws to the bushings on the nickel wires.
7. Diver is dressed out so wires will not snag and transducer is not covered
by any type of diving equipment.
8. In-water surface check:
a. Recheck the location of the earphone.
b. Submerge the transducer (diver with waterline at chest level).
c. Establish communication.
d. Ensure your dive partner’s equipment is properly adjusted and wires are
dressed so as not to snag.
9. Connect the coiled intercom cord to your dive partner’s coiled cord and verify
intercom (secure) communications.
11
Figure 3: Setup of SW-1000-SC system with a LAR V rebreather