Specifications

Figure 4: RCS-3U-HIU smart battery charger

Figure 5: RC-SW-6 multibattery charging station

4.2 BATTERY CHARGING

To recharge the RB-14 battery pack using the RCS-3U-HIU smart charger (provided

with the SW-1000-SC), connect the charger (Fig. 4, #1) to the diver unit’s EM Hi-

Use

connector (Fig. 4, #2) and the power input cord (Fig. 4, #4) to the AC power

source (90–264 VAC, 50–60 Hz). Refer to the instruction sheet provided with the

RCS-3U-HIU charger for complete charging instructions.

If using the RC-SW-6 multi-battery smart charger, connect it (Fig. 5, #2) to the

diver unit’s EM Hi-Use

connector, and plug the power input cord (Fig. 5, #1) into

the AC power source. Refer to the RC-SW-6 user’s manual for more information.

IMPORTANT NOTE, MAG-1004HS only: Be sure to connect the charger’s Hi-Use

connector (Fig. 4, #1 or Fig. 5, #2) to the SW-1000-SC’s EM cable (Fig. 4, #2),

not to its intercom coiled cord (Fig. 4, #3). Electrical current applied through the

coiled cord will not charge the batteries.

Key to Figure 4

(1) Charger’s Hi-Use

connector

(2) Non-coiled cord’s Hi-Use

con-

nector

(3) Coiled cord’s Hi-Use

connector

(4) AC power input plug

Key to Figure 5

(1) AC power input cord

(2) Charger’s Hi-Use

connector