Manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 1. Begin removal of the OEM exhaust
system by loosening the clamp behind hanger brace
(in front of the factory resonator).
Step 2. Disengage hangers from rubber insulators
and remove the OEM exhaust.
Step 3. Begin installation of your new
MAGNAFLOW system by attaching the Resonator
Assembly to the factory outlet. Keep all fasteners
and clamps loose until final adjustment.
Step 6. Once a final position has been chosen for
the new exhaust system, evenly tighten all clamps
from front to rear using the torque specifications on
page one of the instructions. Inspect all fasteners
after 25-50 miles of operation and re-tighten if
necessary.
Step 4. Next use the supplied 2.50" clamp to
attach the Mid-Pipe to the Resonator Assembly.
Step 5. Next use the supplied 2.50" clamps to
attach the Muffler Assembly to the Mid Pipe and the
Tail Pipe Assembly to the Muffler. Fit hangers into
rubber insulators.