Owner`s manual

Installation

2.2 Mounting the Inverter

The inverter base can reach a temperature up to 90°C (194°F), and it is recommended that it should

be mounted on a noncombustible surface*. This surface and the mounting hardware must also be

capable of supporting at least twice the weight of the inverter. To meet regulatory requirements,

the MS Series must be mounted in one of the following positions; as shown in ﬁ gure 2-2:

above or under a horizontal surface (shelf or table),

or on a vertical surface (wall) with the DC terminals to the right.

CAUTION: If the inverter is mounted in a way that the DC terminal ventilation openings

are oriented on the bottom, the ME-CB enclosure must be used. This enclosure prevents

burning material from falling out the bottom and also allows sufﬁ cient ventilation to

prevent the inverter from overheating under normal operating conditions.

After determining the mounting position, refer to the physical dimensions as shown in ﬁ gure 2-3 or

use the base of the inverter as a template to mark your mounting screw locations. After marking

the mounting screw locations, mount the unit with appropriate mounting hardware.

* Noncombustible surface - A surface made of material that will not ignite, burn, support combustion, or release ﬂ ammable

vapors when subjected to ﬁ re or heat as per the ASTM E136 standard. For the most part, these are materials that are

largely comprised of inorganic materials such as stone, steel, iron, brick, tile concrete, slate and glass. Common building

materials such as gypsum board as well as any paint, wall coverings, and certainly wood will not pass.

•

Figure 2-2, Approved Mounting Positions

Shelf or Table Mounted

(unit below)

Shelf or Table Mounted

(unit above)

Wall Mounted

(DC terminal to the right

Wall Mounted (DC terminals on bottom*)

*When the inverter is mounted in this position, the ME-CB

conduit box must be installed.