Installation Manual

Maintenance and Troubleshooting

1) Press and hold the Power ON/

OFF pushbutton.

2) Watch the Charging/Inverting

Status LED, after approximately

15 seconds it should come on

and ﬂ ash rapidly to indicate the

inverter has reset. The Status LED

will go off after the pushbutton is

released.

Figure 4-1, Performing an Inverter Reset

4.4 Resetting the Inverter

Under some fault conditions (e.g., an internal fault), the inverter will need to be reset. Prior to

performing any reset, ensure all AC power (utility, generator, shorepower) is removed from the

inverter’s input.

CAUTION: If AC is connected while performing an inverter reset, damage may occur.

4.4.1 Performing an Inverter Reset

To perform an inverter reset (also known as a “soft reset”):

1. Press and hold the Power ON/OFF pushbutton (see Figure 4-1) for approximately ﬁ fteen (15)

seconds until the Charging/Inverting Status LED comes on and ﬂ ashes rapidly.

2. Once the rapid ﬂ ashing has begun, release the Power ON/OFF pushbutton. The Status LED will

go off after the pushbutton is released.

3. After the inverter reset is completed, press the ON/OFF pushbutton to turn the inverter on.

If the inverter reset fails, you will need to perform a power reset using the procedure below. In

either case, if an internal fault does not clear, the inverter will require repair at an Authorized

Service Center (ASC).

Info: The Power ON/OFF pushbutton is a small momentary type switch which operates

by lightly pressing and releasing. Be careful not to apply too much force when pushing

or the switch might break.

4.4.2 Performing a Power Reset

To perform a power reset (also known as a “hard reset”):

1. Open the inverter’s positive DC disconnect (or disconnect the positive battery cable to the

inverter).

CAUTION: If removing all battery power (positive and negative) to the inverter, remove

the positive battery connections ﬁ rst, then remove the DC negative connections to the

inverter or to any accessory. This will prevent damage to the inverter or to any network

connected accessory.

2. Ensure the inverter and the remote are disconnected from all AC and DC power (the remote

display will be blank).

3. After the inverter has been disconnected from all power for 30 seconds, reconnect the inverter

DC disconnects (or reconnect the positive battery cable) and resume operation.

Info: If DC disconnects are not used, there may be a momentary spark when the positive

battery cable is connected to the inverter’s terminal. This is normal and indicates that

the inverter’s internal capacitors are being charged.