Product Manual
Table Of Contents
- 1.0 Introduction
- 2.0 Installation
- 3.0 Operation
- 4.0 Maintenance and Troubleshooting
- Appendix A – Specifi cations and Optional Equipment
- Appendix B - Battery Information
- Appendix C – Power Consumption and Output Waveforms
- Appendix D – Inverter/Charger Terminology
- Appendix E – Warranty and Service Information
© 2013 Magnum Energy, Inc.Page 3
I ntr oduct ion
Figure 1 - 1 , Pow er Sw it ch, Sta t us LED , and Accessory Connect ion Por t s
1
2
3
4
5
6
Pow er ON / OFF Sw itch
St a t us LED I ndicator
(Charging/Inverting)
St a ck/ Accessorie s Port
(red label – RJ45 connection)
N etw ork Port
(green label – RJ11 connection)
Re m ot e Port
(blue label – RJ11 connection)
Bat t ery Tem p Se nsor Por t
(yellow label – RJ11 connection)
1 .4 Fea t ure s a nd Be nefi t s
The MS-PE Series inverter/charger is designed to allow easy access to wiring, circuit breakers,
and controls. Its die cast baseplate with one-piece aluminum cover ensures maximum durability
with minimum weight, as well as cooler, more effi cient operation.
The front of the MS-PE Series is equipped with the following features (see Figures 1-1 and 1-2):
1
Pow er ON / OFF Sw itch – a momentary pushbutton switch that alternately turns the inverter
on or off.
2
St a t us LED I ndicator – this green LED illuminates to provide information on inverter
or charger operation.
3
St a ck/ Accessorie s Port ( red la bel) – a RJ45 port that connects to the ME-RTR router,
which is used to confi gure and synchronize multiple MS-PE units to operate in parallel for
increased power capacity.
CAUTI ON : Only connect this parallel stack port to the ME-RTR router. Although
the cabling and connectors used in this network system are the same as ethernet
connectors, this network is not an Ethernet system. Attempting to connect these two
different systems may cause damage and is not covered under warranty.
I nfo: To connect MS-PE Series inverters in parallel, the optional ME-RTR router must
be installed.
4
N etw ork Port ( gr een label) – a RJ11 port for connecting optional network capable
accessories (e.g., Auto Gen Start module or Battery Monitor).
5
Re m ot e Port ( blue label) – a RJ11 port for connecting the optional remote controls
(ME-RC, ME-ARC, or ME-RTR).
6
Bat t ery Tem p Se nsor Por t ( yellow la be l) – a RJ11 port for connecting the remote
Battery Temperature Sensor (BTS) accessory.