Product Manual
Table Of Contents
- 1.0 Introduction
- 2.0 Installation
- 3.0 Operation
- 4.0 Maintenance and Troubleshooting
- Appendix A – Specifi cations and Optional Equipment
- Appendix B - Battery Information
- Appendix C – Power Consumption and Output Waveforms
- Appendix D – Inverter/Charger Terminology
- Appendix E – Warranty and Service Information
© 2013 Magnum Energy, Inc.Page 5
I ntr oduct ion
Figure 1 - 3 , Left Side Feat u r e s
15
14
16
13
Ex haust
Air Ve nts
(back side &
right side rear)
Mode l/ Serial
N um ber Label
AC I nput Cir cuit
Break e r ( CB1 )
AC Access Cover
The left side of the MS-PE Series inverter is equipped with the following features (see Figure 1-3):
1 3
Ex haust Air Vent s – ventilation openings that allow heated air to be removed by the
internal cooling fan. The exhaust air vents are located on the back side and at the rear
on the right side; see Figure 2-3 for the location of the air vents.
1 4
Mode l/ Serial N um ber Label – includes model/serial number information, date of
manufacture, and inverter and charger specifi cations. See the MS-PE Specifi cations
section in Appendix A for more information and a list of available models.
1 5
AC Access Cover – provides access to the internal AC wiring terminal block. This
terminal block is used to hardwire all inverter AC input and output wiring connections.
Remove the two screws to access the AC wiring terminal block.
1 6
AC I nput Cir cuit Br eaker ( CB1 ) – this circuit breaker protects the unit’s internal
charger wiring and pass-thru relay while in Standby mode. The circuit breaker pops out
when it opens—press in to reset. The input circuit breaker is not branch-rated, therefore
branch-rated circuit breakers must be installed in the inverter’s input and output wiring.
CAUTI ON : The inverter’s internal AC transfer relay is rated for 30 amps. The pass-
thru current must be no greater than 30 amps, or damage to the relays may occur.