Product Manual
Table Of Contents
- 1.0 Introduction
- 2.0 Installation
- 3.0 Operation
- 4.0 Maintenance and Troubleshooting
- Appendix A – Specifi cations and Optional Equipment
- Appendix B - Battery Information
- Appendix C – Power Consumption and Output Waveforms
- Appendix D – Inverter/Charger Terminology
- Appendix E – Warranty and Service Information
© 2013 Magnum Energy, Inc.Page 13
I nst alla t ion
Figure 2 - 4 , D C a n d Bat t e r y Tem perat u r e Sensor W iring
DC System Grounding point
[Electrode Conductor
(i.e., ground busbar)]
MS-PE Series
Inverter/Charger
(front view)
Battery Temp Sensor Cable*
Inverter’s DC Negative Busbar
Inverter’s DC Positive Busbar
Inverter’s Equipment Ground Wire
BTS
BTS
Battery Bank
Battery Bank’s Equipment Ground Wire
Battery Bank’s Negative Cable
Battery Bank’s Positive Cable
MMP-E enclosure – designed for single inverter
installations (includes DC disconnect breaker, DC shunt for
battery monitor, and inverter DC busbars). If multiple
inverters will be installed, use a MP-E enclosure – designed
to allow up to four inverters to be connected together.