Installation Manual

Page 2

Installation

2.0 Installation

Review this section and the Important Product Safety Instructions on page ii before proceeding

with the installation of your remote.

WARNING: Installations should be performed by qualiﬁ ed personnel, such as a licensed

or certiﬁ ed electrician. The installer determines which safety codes apply and ensures

all applicable installation requirements are followed. Applicable installation codes vary

depending on the speciﬁ c location and application.

CAUTION: When connecting battery power to the inverter, all battery negative

connections must be connected prior to the battery positive connections. When removing

battery power from the inverter, the battery positive should be removed before any

battery negative connections are disconnected. This prevents any communication chips/

lines from becoming the DC return path to the battery—causing permanent damage to

all connected accessories.

Summation: Ensure all battery negative circuits are always connected before connecting

or disconnecting battery positive.

2.1 Pre-Installation

Before proceeding, read the entire Installation section to determine how best to install your ME-

ARC remote. The more thorough you plan in the beginning, the better your inverter needs will

be met.

2.1.1 Installation Guidelines

• Before connecting any wires determine the remote’s cable route throughout the home or ve-

hicle/boat, both to and from the inverter.

• Always check for existing electrical, plumbing, or other areas of potential damage BEFORE

drilling or cutting into walls to mount the remote.

• Make sure all wires have a smooth bend radius and do not become kinked.

• If installing this remote in a boat, RV, or truck ensure the conductors passing through walls,

bulkheads, or other structural members are protected. This minimizes insulation damage

(such as chaﬁ ng) which can be caused by vibration or constant rubbing.

2.1.2 Unpacking and Inspection

Carefully remove the ME-ARC remote from its shipping container and inspect all contents. Verify

the following items are included:

• The ME-ARC remote display • Bezel • 50’ remote cable

• Eight #8 x 3/4 Phillips screws • ME-ARC Owner’s Manual

If items appear to be missing or damaged, contact your authorized Magnum Energy dealer or

Magnum Energy.

IMPORTANT: Save your proof-of-purchase as a record of your ownership; it is needed if the unit

should require in-warranty service.

2.1.3 Tools Required

Installing the remote control is simple and requires the following tools:

• Phillips screwdriver • Level • Drill

• Cut-out tool (knife/saw) • Pencil • Drill bit (7/64”)