User Guide

57. Remove the MAF from the airbox by loosening
the connector clamp.
58. Pull back the grey locking latch on the MAF
electrical connector and then squeeze the connector to
remove it.
59. Remove the tape and split loom from the har-
ness to about 6” below the MAF connector. Locate
the Brown/Yellow and the solid Brown wires. These
are the Intake Air Temperature (IAT) sensor wires on
the connector. Cut these two wires approximately 2”
below the connector.
To connector
not used
To computer
60. Using the four crimp/shrink connectors and the
two pieces of 63” long white wire supplied, extend the
IAT wires that run to the vehicles computer. The two
wires to the MAF CONNECTOR will no longer be
used. Strip about ¼” of insulation from the ends of
the BROWN/YELLOW and SOLID BROWN wires
to the computer and crimp the connectors on. Using a
heat gun or blow dryer set on HIGH; shrink the insula-
tion on the connectors so that it contracts around the
wires completely. You must shrink the insulation,
as crimping the connectors alone is not enough to
secure them!
12/05
Page 17
2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com