User Guide
81. Install the Injector Wiring Adaptors on all eight
fuel injectors. Note that the cut-away side of the con-
nector goes towards the top of the injector.
Cut-away
84. Using the piece of 5/16” EVAP hose supplied cut
it into two pieces. One piece 28” long and the other
16” long. (The hoses are shown shorter for clarity.)
Starting with the longer of the two, assemble the hose
with the test port on one end and the right angle on the
other using the #6 clamps supplied. On the remain-
ing hose, assemble it with the straight fi tting, squeeze
fi tting and clamps.
83. Using a sharp shop knife, cut the hard plastic tube
where it covers the the barbed end of the EVAP fi t-
tings. Take care not to damage the fi ttings as they will
be reused.
82. Locate the two hard plastic EVAP lines previously
removed.
Right angle fi tting
Test port fi tting
28”
EVAP
hose
Squeeze
fi tting
# 6 clamps
16” EVAP hose
Straight fi tting
12/05
Page 23
2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com