User Guide

86. Re-connect the Purge solenoid electrical con-

nection, then install the right angle ﬁ tting of the long

EVAP hose to the top connection of the Purge sole-

noid. Connect the squeeze ﬁ tting of the shorter EVAP

hose to the lower connection of the solenoid.

87.

Connect the remaining end of the short EVAP

hose to the ﬁ tting on the passenger (left) side of the

inlet manifold above the supercharger drive shaft.

88. Locate the Vacuum accesory line at the ﬁ re wall

and install the length of 1/8 hose supplied onto the end

of the check valve.

Vacuum accessory line

and Check valve

1/8” hose

85. Connect the long EVAP hose with the Test port

ﬁ tting to the ﬁ re wall connection. Route the other end

of the hose forward between the driver side coil pack

and the fuel rail. Pass the hose under the inlet maifold

and supercharger drive to the EVAP purge solenoid.

12/05

Page 24

2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com