User Guide

95. Cover the extended ETC harness with the new

split loom supplied. route the extended harness under

the throttle body and install the connector onto the

throttle body

94. Using the color coded lengths of wire and crimp/

shrink connectors supplied supplied, extend the six

throttle body connector wires. Be sure to correctly

match the extention wire color to the harness and at

the throttle body connector. Strip about ¼” of insula-

tion from the ends of all the wires. Crimp the connec-

tors on and shrink the insulation so that it contracts

around the wires completely.

96. Here is the new acessory drive belt routing dia-

gram.

S/C

W/P

CRANK

TEN

93. Remove the tape and split loom from the harness

to about 6” below the Electric Throttle Control (ETC)

connector. Cut all these wires approximately 2” below

the connector.

ETC Connector

ALT

P/S

12/05

Page 26

2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com