User Guide

134. Mount the intercooler coolant pump on the
outside of the frame rail just ahead the where the res-
ervoir was located using the two Adel clamps and self-
tapping screws. Drill two 1/4” holes in the locations
shown for the self-tapping screws. Note the position
of the pump inlet, outlet and electrical connections.
Plug the pump harness connector into the end of the
pump.
2.750”
.750”
3.750”
Pump
Outlet
Pump Inlet
Electrical
connection
135. Re-install the windshield washer reservoir. Se-
cure it with the front, rear and bottom fasteners. Re-
move the rubber plug from the pump barb and reattach
the small fl uid hose, then connect the washer pump
electrical connector. Replace the inner fender panel
and secure it with the crosshead screws. Re-install the
fi ller cap on the neck in the engine compartment.
136. Make a hole in the passenger side of the splash
shield as shown for the intercooler coolant hoses to
reach the heat exchanger.
Hole
133. Route the pump harness and connector down to
the pump through the harness hole next to the battery
platform.
Pump
harness
12/05
Page 36
2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com