User Guide

138. Assemble the heat exchanger by peeling the
backing paper off the two short plastic strips and apply
them to the inside of the upper mounts.
137. Using a sharp knife or hole-saw make two 1-
1/8” holes in the side from the back side of the splash
shield. This can be easily done by pulling down on
the bottom edge of the front fascia or ”Nose” cover.
139. Apply the longer third strip to the left front face
of the heat exchanger 4-1/2” from the top edge as
shown.
140. Connect a length of 3/4” hose cut a piece 80”
long and attach it to the upper barb of the heat ex-
changer. Install a 22” piece from the remaining length
on the lower barb of the heat exchanger. Secure the
hoses with #10 clamps.
22”
80”
12/05
Page 37
2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com