User Guide

149. Route the elbow hose from the lower barb of the
reservoir down to inlet of the coolant pump.
Hose to heat exchanger
Hose from coolant
reservoir
Washer reservoir
150. Connect the hose from the lower heat exchanger
barb to the outlet on the pump through the new hole in
the splash shield. Secure the hose with #10 clamps.
152. Using the remaining hose cut from the molded
90 degree “elbow” hose, trim this piece to 13” long
and install it onto the right barb on the intercooler
water manifold. Connect the other end to the upper
barb on the intercooler reservoir. Secure the hose with
#10 clamps.
151. Route the hose from the upper barb down
through the new hole in the right side of the splash
shield. Continue the hose up into the engine com-
partment and connect it to the rear barb of the water
manifold. Secure the hose with #10 clamps.
Hose to water manifold
Hose from heat exchanger
Hose to reservoir
12/05
Page 40
2005-2006 Pontiac GTO LS2 Supercharger Installation Instructions magnacharger.com