User manual

RE-ADJUSTING THE THREAD TENSIONING
All JessEm lifts feature our patented thread
tensioning design. The design holds the position
wherever you set the height. Thread tension is set at
the factory and depending on the amount of use you
may have to reset this adjustment periodically.
1. To adjust the thread tension, turn the Rout-R-Lift™
upside down on a table with the threaded height
adjustment rod facing you (Fig 6).
2. With a 7/16” open end wrench, loosen the 1/4 -
20 hex nut (Item# 21) located behind the plate the
threaded rod (or lead screw) is mounted on (Fig. 6).
3. Rotate the brass tensioning collar (Item# 23)
counter clockwise so it tightens against the rubber
washer. NOTE: A drop of oil on the rubber washer
eases the rotation of the brass ring against the
washer. When you tighten the brass collar and the
1/4” - 20 hex nut (Item# 21), the set screw must seat
into one of the vertical grooves in the brass collar.
FIG. 9
JESSEM TOOL LIMITED WARRANTY
All JessEm products are warranted to be free
from defects in material and workmanship.
JessEm will repair or replace any product which
upon inspection proves to be defective for a
period of (1) year from dated receipt and proof
of purchase. All warranty claims should be
made direct to JessEm Tool Company. Contact
JessEm for a warranty claim return authorization
and instructions to proceed. The consumer is
responsible for shipping costs to return product
to JessEm Tool Company. We will repair or
replace the product at our discretion and
JessEm Tool will return shipment to you at no
charge.
WARRANTY LIMITATIONS
This warranty does not cover:
! Repairs or alterations made or attempted by
anyone other than JessEm Tool Company or
an authorized JessEm service professional.
! Normal wear and tear
! Abuse, misuse or neglect.
! Improper care or maintenance.
! Continued use after partial failure.
! Products that have been modified in any way.
! Products used with improper accessories.
! Premature thread wear due to adjusting
height with electric or cordless drill.
5
BOSCH 1613 (THRU HOLES) BOSCH 1613 & 1450 BOSCH 1604, 1617 EVS
BOSCH 1611 & 1615
FEIN RT1800
PERFORMANCE CLF20&50
DEWALT 615 DEWALT 621 DEWALT 625
ELU 3337-9
BOSCH 1619