Instruction manual

Specific Safety Rules
.
1. Hold tool by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring or its own cord. Contact
with a
"live" wire
will also make exposed metal parts of the tool "live" and shock
the operator.
Be sure no one is below when using the tool in high locations.
2. Always be sure you have a firm footing.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately after operation: they may
be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
The followings show the symbols used for tool.
V ................................. volts
A ................................. amperes
Hz ................................. herts
kg ................................. kilograms
h
................................. hours
min
................................. minutes
S ................................. seconds
% ................................. alternating current
- direct current
____
.................................
n, ................................. no load speed
-
................................. alternating or direct current
-
U ................................. Class 11 Construction
A ................................. splash-proof construction
bb ............................
watertight construction
... /min
@ ................................. number of blow
................................ revolutions or reciprocation per minute
4