Instruction manual

Hook
The hook is convenient for temporary hanging the tool. When using the hook, pull it out in
"A" direction and then push it in B direction to secure in place.
When not using the hook, return it back to its initial position by following the above proce-
dures in reverse.
A Hook
\-B
ASSEMBLY
Depth adjustment
The depth can be adjusted by turning the
locking sleeve. Turn it in
"A" direction for
less depth and in
"B" direction for more
depth. One full turn of the locking sleeve
equals 1.5 mm (1/16") change in depth.
I
Locking sleeve
Adjust the locking sleeve so that the distance between the tip of the locator and the screw
head is approximately 1 mm (3/64") as shown in Fig. A or B. Drive a trial screw into your
material or
a piece of duplicate material. If the depth is still not suitable for the screw, con-
tinue adjusting until you obtain the proper depth setting.
Approx. 1 mm (3/64")
-1 I-
Locator A'
Fig. 1
Approx. 1 mm (3/64")
-I I-
Locator -
Fig. B
6