Instruction manual

Removing or installing bit
CAUTION:
Always be sure that the tool is switched off and unplugged before removing or installing
the
bit.
To remove the bit, first pull the locator out of the locking sleeve. Then grasp the bit with a
pair of pliers and pull the bit out of the magnetic bit holder. Sometimes, it helps to wiggle
the bit with the pliers as you pull.
To install the bit, push it firmly into the magnetic bit holder. Then install the locator by
pushing
it firmly back onto the locking sleeve
Locking sleeve
I
Locator
Ll4L
Magnetic bit holder
OPERATION
Fit the screw on the point of the bit and
place the point of the screw on the surface
of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw
the
tool as soon as the clutch cuts in. Then
release the trigger.
CAUTION:
*When fitting the screw onto the point of the bit, be careful not to push in on the screw.
If
the screw is pushed in, the clutch will engage and the screw will rotate suddenly. This
could damage a workpiece or cause an injury.
*Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may
be damaged.
7