Instructions
13 ENGLISH
NOTE: Depending on the conditions of use and the
Tool / battery protection system
-
-
Overload protection
-
uation, turn the tool off and stop the application that
tool on to restart.
Overheat protection
Overdischarge protection
Switch action
CAUTION: Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION: Switch can be locked in "ON" posi-
tion for ease of operator comfort during extended
use. Apply caution when locking tool in "ON"
CAUTION: Do not install the battery cartridge
with the lock button engaged.
CAUTION: When not operating the tool,
depress the trigger-lock button from side to
lock the switch trigger in the OFF position.
Fig.3: 1.
Fig.4: 1. Switch trigger 2.3. Trigger-
) side and pull
the switch trigger. Release the switch trigger to stop.
)
side.
pulling the switch trigger, and then release the switch
release it.
Speed adjusting dial
Fig.5: 1.
-
speed.
Number Speed
1 1,000 min
-1
2 1,200 min
-1
3 1,400 min
-1
4
-1
5 1,800 min
-1
NOTICE: When changing the speed dial from "5"
to "1", turn the dial counterclockwise. Do not turn
the dial clockwise forcibly.
Overload and overheat indicator
lamp
Fig.6: 1. Indicator lamp
If the tool is operated with excessive load, the tool stops
case, reduce the load on the tool.
and the indicator lamp lights up in red. In this case, let
Electronic function
Constant speed control
kept constant even under the loaded condition.
Soft start feature
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Assembling the tool bag
1.
Fig.7
2.
Fig.8: 1.
3.
Fig.9: 1. Hook and loop fastener 2.