Instructions
14 ENGLISH
Installing the abrasive disc
Fig.10: 1.2. Pad
Adjusting the pipe length
CAUTION: When adjusting the pipe length,
hold the tool horizontally. Otherwise, the pipe
NOTICE: Do not extend the pipe beyond the
limit.
the tool.
Fig.11: 1. Sleeve 2. Pipe
the length of the pipe, and then tighten the sleeve.
Installing or removing the dust
collection brush
Before sanding operation, install the dust collection
Fig.12: 1.2. Sanding head
Fig.13: 1.2. Sanding head
Hex wrench storage
Fig.14: 1. Hex wrench
When not in use, store the hex wrench as shown in the
Installing or removing the pad
Fig.15: 1. Hex wrench 2. Bolt 3. Pad
wrench. To install the pad, perform the removal proce-
dure in reverse.
CAUTION: Make sure that the pad is secured
properly.
loss of control.
Connecting a vacuum cleaner
Optional accessory
the vacuum cleaner to the dust nozzle using the front
cuff 24.
Fig.16: 1. Hose of the vacuum cleaner 2.
24 3. Dust nozzle
Installing or removing the extension handle
Optional accessory
To install the extension handle, attach the extension handle to the
of the tool into the holder of the extension handle. To remove the
extension handle, perform the installation procedure in reverse.
Fig.17:
1.2.3. Holder 4.
OPERATION
CAUTION: Only use Makita genuine pads for
sanding (optional accessories).
CAUTION:
Make sure the work material is secured
and stable. Falling object may cause personal injury.
CAUTION:
on the switch handle and the other hand on the
front grip when operating the tool.
CAUTION:
Do not run the tool at high load over
an extended time period.
CAUTION:
Be careful not to touch the rotating part.
NOTICE: Never force the tool.
pad, or shorten tool life.
NOTICE: Continuous operation at high speed
may damage work surface.
1.
with the work surface.
2.
work surface. Move the tool in an overlapping pattern in
Fig.18
Operating the tool with the extension handle
Optional accessory
CAUTION:
switch handle and the other hand on the extension handle
when operating the tool with the extension handle.
1.
Fig.19: 1. Belt
2.
Fig.20: 1. Holder 2. Belt
3. Put the end of the extension handle into the holder
to support the tool.
Fig.21: 1.2. Holder
extension handle.
Fig.22
Fig.23