Use and Care Manual

23
Lift the chain (6) over the sprocket (5).
Guide the chain from above about halfway into the groove
(7) on the guide bar.
CAUTION:
Note that the cutting edges along the top of the chain must
point in the direction of the arrow!
Mounting the guide bar and saw chain
Use the universal wrench delivered with the chain saw for
the following work.
Put the chain saw on a stable surface and carry out the fol-
lowing steps for mounting the guide bar and saw chain:
Release the chain brake by pulling the hand guard (1) in
direction of arrow.
Unscrew retaining nuts (2).
Pull o the sprocket guard (3).
Only for the QuickSet guide bar
CAUTION:
Before doing any work on the guide bar or chain, al-

spark plug (see “Replacing the spark plug”). Always wear
protective gloves!
CAUTION:
Start the chain saw only after having assembled it com-
pletely and inspected.
Put the guide bar (4) on and push it against the sprocket
(5).


symbol: